UTICA BOILERS JE Installation Manual download pdf (Page 15)

When starting section assembly, clean nipples and

nipple ports.

Coat nipples and nipple ports with Hercules Grrip or

other good sealant. See Figure 9.

Place nipples in ports. Take care to seat them

squarely to prevent cocking. Figure 10.

When pulling sections together with tie rods, insert

tie rods in holes nearest to nipple ports. Move tie rods

to proper location, if necessary, only after sections are

fully pulled together. See insert Figure 11.

Oil or lubricate threads, insert rods in lugs with

washers under nuts and tighten uniformly and

evenly so that sections are pulled parallel as they go

together. When all sections are pulled up, locate tie rods

in alternating pairs of upper and lower holes between

adjacent sections. See Figure 11.

Be sure both ends of completed section assembly are

resting evenly on both ends of base.

Apply furnace cement at joints of sections front, top

and back. Apply furnace cement where sections join

the base. See Figure 12.

Place necessary plugs and control wells in correct

locations. See Figure 31 page 24.

A. Plug all other tappings, leaving air vent in top of

one of end sections, and connect water.

B. Fill boiler with water until it runs out air vent. See

Figure 31 port D page 24.

C. Hydrostatically test boiler in accordance with

applicable codes.

D. Check for leaks before continuing with assembly.

E. Drain and remove unnecessary plugs.

Figure 9

Figure 10

INSTALLATION – ASSEMBLY

Figure 11

Apply non-asbestos furnace cement to joints on all sides of boiler.

Figure 12

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

UTICA BOILERS JE Installation Manual Page 15